Air-Cooled Motors
The motors have a cast iron standard design, adapted to withstand the following stresses :
- load to the shaft end
- pressure below 0.5 bar
- vacuum up to 10mbar (motor stopped)
- temperature below 1 050°C
- power up to 160 kW (S1)
Type ET 476
A heat shield is mounted on the motor side of the longer shaft. A second flange allows the motor to be mounted according to the customer’s required installation. Unsealed, it used for work at atmospheric pressure and temperatures below 750°C.
Type ET 572
Water jacket before the flange and outside the customer’s installation. Compatible with all maximal stresses and especially with light fans
Type ET 933
Water jacket after the flange and inside the customer’s installation. Compatible with all maximal stresses. This version has a conical receptor at the rear of the motor allowing a monobloc fan to be fitted.
Membres - Member of
Audité-Certifié - Certified by
